This machine is widely used in rubber, plastic, wire, cable scientific research and other units, the machine can cut various specimens with Shore hardness greater than 40 degrees and thickness of 1-12 mm. The surface of the cutting sheet material is smooth and flat; the thickness and dimensional tolerance can be controlled at +0.2; no need for polishing, the specimen can be cut directly. 【Relevant Standards】

Not at the moment

【Scope of application】: This machine is widely used in rubber, plastic, wire, cable scientific research and other units, the machine can cut various specimens with Shore hardness greater than 40 degrees and thickness of 1-12 mm. The surface of the cutting sheet material is smooth and flat; the thickness and dimensional tolerance can be controlled at +0.2; no need for polishing, the specimen can be cut directly. 【Technical Parameters】: 1. The width of the worktable is 300 mm 2. Slice thickness 12mm 3. Cutting blade (length*width*height) 300*125*10mm 4. Overall dimensions: length x width x height 600x400x1000 [Instrument features]: This machine is composed of fuselage, transmission, adjustment, operation and other parts, and the structure and use of each part are introduced as follows: 1. Fuselage and transmission The lower part of the fuselage is the machine, the inside is equipped with the motor and electrical accessories, the outside is equipped with the motor start and stop switch, the upper part of the fuselage is the working part, equipped with the left and right frames, the worktable, the pressing shaft, the feeding shaft and the adjustment mechanism, etc. When working, the start switch, When the motor is turned on, the planer starts running, and the stop switch is when the planer stops running. Note: The model with speed regulation can adjust the appropriate speed according to the hardness of the rubber, generally slow down. The transmission is driven by a motor, which drives the transmission shaft to rotate through the main and attached pulleys. The feeding shaft rotates under the drive of the gears installed at both ends of the transmission shaft, and then the gears on the feeding shaft drive the pressing shaft to rotate at the same time. 2. Operation and adjustment The right side of the operation handwheel is generally used when adjusting, and this wheel is idling when working. Adjustment of slice thickness, by turning the adjustment handwheel above the frame, so that the holding shaft falls or rises to the appropriate feed thickness; by adjusting the screws under the frame, the feeding shaft rises (or falls) to the desired slice thickness. [Installation and maintenance]: 1. After the machine enters the work site, it is loaded horizontally into the base. 2. Remove the anti-rust grease from the exposed surface, and check whether the components and electrical appliances are loose, lost or damaged due to shipment. 3. Connect the power supply and install the ground wire, and pay attention to the direction of motor operation should be consistent with the direction shown by the arrow on the pulley cover. 4. Check whether the tightness of the V-belt is appropriate, if not, open the back cover and adjust it with the reverse nut connecting the bottom plate of the motor and the base of the machine. 5. Before the machine starts, add oil lubrication to each refueling position, (no less than two times per shift in each position) coated with a small amount of semi-hard grease on the transmission gear surface, pay attention to the lower feeding shaft and the upper feeding shaft do not stick to oil stains, and then turn the handwheel and adjust the handwheel to check whether each part is running flexibly 6. In addition to frequent refueling and lubrication, keep the machine clean, pay attention to maintenance and operation safety (do not operate with gloves and help feed with hands). 7. If you find that the operation is abnormal or the machine parts are damaged, you should stop and repair immediately. Note: The machine does not have the function of planing the ribs of the waterstop, if it is a ribbed waterstop, please remove it first and then plane it.